Common causes of high temperature mesh belt surface damage and emergency maintenance methods

Common causes of high temperature mesh belt surface damage and emergency maintenance methods

As a transmission belt, the high temperature mesh belt plays an important role. However, like other mechanical equipment, the mesh belt will be worn during long-term use, which may have an adverse effect on its performance, efficiency and service life. Therefore, regular inspection and maintenance are essential for the normal operation of the high temperature mesh belt.

Causes of mesh belt wear

1.Friction

During the operation of the high-temperature mesh belt, friction will occur between the material or equipment. Long-term friction will cause wear and tear on the surface of the mesh belt, thus affecting its transmission efficiency and life.

2.Corrosion

When the high-temperature mesh belt is exposed to humid air or comes into contact with environmental factors such as chemicals, it is prone to corrosion, resulting in rust and oxidation on the surface of the mesh belt, further accelerating its wear.

3.Dislocation

Improper adjustment of the machine or errors during installation may result in inappropriate clearance between the high-temperature mesh belt and other components, causing misalignment and distortion of the mesh belt, increasing friction and wear.

4.Other causes

Overload: When the material exceeds the carrying capacity, it may cause deformation and breakage of the mesh belt.

Material: If the material of the high-temperature mesh belt selected is not compliant, it will cause the mesh belt to break and affect the service life of the mesh belt.

Maintenance measures for mesh belt

Clean regularly

Clean the high-temperature mesh belt regularly to remove dirt and impurities on the surface. Excessive accumulation of these stains and debris can cause the metal mesh belt to jam, and regular cleaning is required to reduce friction and corrosion.

Installation and Debugging

When installing the mesh belt, make sure it is properly tight. Correct mesh belt position adjustment can ensure its normal operation while avoiding potential problems caused by over-tightening or over-loosening.

Pay attention to the operation status

Always pay attention to the operating conditions of the equipment. If the high-temperature mesh belt is found to be deviating, take immediate action to adjust the correction device to ensure the normal operation of the equipment.