Three common misunderstandings about deformation and broken wires of enrober mesh belt.

In the food processing industry, enrober mesh belt is a commonly used metal mesh belt for frying machine equipment, breading machine equipment, sizing machine equipment, etc.

However, many companies suffer from frequent deformation, broken wires and short life of enrober mesh belt.

Based on many years of industry service experience, the technical team of Hengshui Qualified Filter Screen Co., Ltd. has summarized three common misunderstandings and targeted solutions to help you reduce the frequency of replacement and improve production efficiency.

01 Ignore material matching
Root cause of the problem
Low-priced mesh belts have high impurity content, poor fatigue resistance, and are easy to break at the bend.
Hengshui Qualified Filter Screen Co., Ltd. Response strategy
a. Accurate material selection: Choose the appropriate mesh belt material according to different usage conditions, and inform the mesh belt manufacturer of the usage status before purchasing the mesh belt.
b. Raw material traceability: Select raw material manufacturers with good brand reputation, which can track and trace the raw materials.

02 Ignore process details
Source of the problem
a. During the production of the mesh belt, the mesh wire is bent and woven, and there are indentations at the bends. The seemingly "insignificant" indentations are often the source of breakage.
b. The load-bearing capacity of the mesh belt is judged based on experience, and the load-bearing capacity of the mesh belt cannot be accurately determined.
Hengshui Qualified Filter Screen Co., Ltd.'s response strategy
a. The type B mesh belt of Hengshui Qualified Filter Screen Co., Ltd. uses imported equipment for bending, and the weaving process comes from Japan, which has better details.
b. The engineering department of Hengshui Qualified Filter Screen Co., Ltd. has the endorsement of the relevant R&D center, has the ability to digitize the load-bearing capacity of the mesh belt, and can design the mesh belt specifications according to the customer's usage needs and recommend suitable mesh belts.

03 Ignore the acceptance of the mesh belt
Source of the problem
The mesh belt acceptance link does not carry out specification approval, and it is OK to be able to be transported on the machine. It may cause the mesh belt to not match the drawing and is not suitable for use with this equipment.
Hengshui Qualified Filter Screen Co., Ltd.'s response strategy
a. Support customers in the approval and acceptance of mesh belt materials and mesh belt specifications to ensure that the mesh belt drawings correspond one to one, meet the design requirements of the engineering department, and meet actual use.
b. Provide customers with correct usage tutorials.